February 7, 2015

树莓派安装TP WN322G+驱动

首先查看usb设备 pi@raspi ~ $ lsusb Bus 001 Device 002: ID 0424:9514 Standard Microsystems Corp. Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 001 Device 003: ID 0424:ec00 Standard Microsystems Corp. Bus 001 Device 004: ID 0ace:1215 ZyDAS ZD1211B 802.11g 注意,最后一行为无线网卡信息 打开https://wiki.debian.org/WiFi,查看是否有对照型号的固件 安装对应的固件 pi@raspi ~ $ sudo apt-get install zd1211-firmware 完成后使用iwconfig检查是否已经安装成功 pi@raspi ~ $ iwconfig wlan0 IEEE 802.11bg ESSID:off/any Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm Retry long limit:7 RTS thr:off Fragment thr:off Power Management:off lo no wireless extensions. Read more

August 12, 2014

树莓派中使用TL-WN725N

Raspbian版本 2014-01-07-wheezy-raspbian.img 下载地址为http://cdn.lyq.wiki/res/8188eu-20140616.tar.gz 首先固网链接树莓派,通过SSH登录 wget http://cdn.lyq.wiki/res/8188eu_31024_614.zip unzip 8188eu_31024_614.zip sudo mv 8188eu.ko /lib/modules/`uname -r`/kernel/drivers/net/wireless sudo chown root:root /lib/modules/`uname -r`/kernel/drivers/net/wireless/8188eu.ko sudo mv rtl8188eufw.bin /lib/firmware/rtlwifi/ sudo chown root:root /lib/firmware/rtlwifi/rtl8188eufw.bin sudo depmod -a sudo modprobe 8188eu 然后编辑/etc/netwok/interfaces,添加以下内容 allow-hotplug wlan0 auto wlan0 iface wlan0 inet manual wpa-roam /etc/mywpa.conf iface default inet dhcp 新建mywpa.conf写入链接配置vi /etc/mywpa.conf network={ ssid="YOUR SSID" proto=RSN key_mgmt=WPA-PSK pairwise=CCMP TKIP group=CCMP TKIP psk="YOUR PASSWORD" } 重启系统

© unixetc.com 2012 - 2019
README